TFT Mid-Force Nozzle Series

Description

About the MID-FORCE Series The dual pressure MID-FORCE automatic nozzle has a wide flow range of 70-200 gpm (265-760 l/min) that gives superior performance in both handheld and monitor nozzle configurations. Handheld: For use with a 1.5″ (38mm), 1.75″ (45mm) or 2″ (52mm) hose. The baffle of the nozzle is equipped with a low-pressure override knob, which allows the nozzle to achieve even greater flows at lower nozzle pressures. All nozzles are regulated to 100 psi ±15 psi (7 bar ±1 bar) or 75 psi ±15 psi (5 bar ±1 bar) according to NFPA 1964 flow requirements. It is adjustable from a straight stream to a dense fog pattern with your choice of molded rubber fog teeth for a fully-filled “power fog” pattern or stainless steel spinning teeth. In the standard mode, the MID-FORCE nozzle maintains a 100 psi (7 bar) operating nozzle pressure (75psi / 5bar for low pressure version). This gives you the desired ability to aggressively conduct a hard- hitting fire attack. However, with a twist of the knob on the front of the nozzle, you switch to the low pressure mode, which immediately reduces the nozzle’s operating pressure to around 55 psi (3 bar) (45psi / 3bar for low pressure version). This exclusive TFT feature provides you with the unique ability to change operating nozzle pressure depending on the situation, thereby allowing maximum flow at a lower nozzle pressure. MID-FORCE’S are also available with TFT’s IMPULSETM trigger valve system. Monitor Nozzle: An automatic dual-pressure control with a flow capacity of 70-200 gpm (260-760 l/min). The nozzle may be switched from 100 psi (7bar) to low pressure. It includes flush without shutting down and molded rubber teeth for full-fill “power fog” pattern. For use on TFT Tornado and EF1 RC monitor only.